Drytac JetMounter Manual 25" Roll Laminator
Manual 25" laminator for mounting prints using adhesive coated papers or boards
25" wide
Can mount boards up to 1/2" thick
Uses all of our adhesive coated boards
Tables fold-up for compact storage
Rugged Design and Ready to use out of the box
Great for mounting larger prints
Professional grade silicon rollers provide even pressure and insure bubble free results and any exposed adhesive on the board will not stick to the rollers
To set the gap between the rollers to match the thickness of your board, place your board between the rollers and close the rollers by turning the height control knob until there is no light between the board and the rollers.(see picture 1) Then tighten the rolls a half turn on the height control knob. (If you are using the same boards all the time, this will only need to be done once.)
Peel back the first inch of the release liner
Smoothly tack down your print to the inch of exposed adhesive
Insert the tacked edge into the laminator, remove the remainder of the release liner (see picture 2)
Hold your print up so that it is smooth against the rollers
Turn the handle to pull your print and board through the laminator (see picture 3)
Your print will be mounted
Trim your print if desired
Specifications Width 25 inches
Maximum roll opening - 1"
Roll covering - Silicon
Cabinet construction - metal
Weight 32 pounds
Warranty - 1 year
Easy to Use
Specifications